Information pretaining to Engine, Transmission and Driveline
CHECK ENGINE Light Diagnostic Mode 1. Start engine (if possible). Move transmission shift lever through all gear positions, ending in Park. Turn...
1. Ensure battery connections are tight and not corroded. Ensure 60-pin connector on Single Board Engine Controller (SBEC) is fully engaged and...
Here you go gang... The engine layout of the 12V VE Pumped Cummins engine... I know the image is a bit poor but its better than nothing...
I have a 92' power wagon 250 with the 5.9L 12V intercooled, A/C, power windows, locks, and lots of electrical problems! My biggest problem right now...
1993 Dodge D-250 w/ cummins. I need a quick bit of info on the belt tensioner. 1. Does it come off when the bolt in the middle is removed? ...
errr....those suck....mine went quick...one day 100 miles from home i got the click click. a week goes by and it happened again. both times i...
will the NV4500 bolt up to a 727 bellhousing, once I replace the flex plate with a flywheel?
Taz i found you a set of cheap injectors even you could afford... ...
My wait to start light is not functioning, I checked the relays they can be powered up (using engines remote start switch) and fire up the heater...
Here is my high idle mod for my truck. It a simple constant duty solenoid that pushes the throttle arm for about 1,200 RPM's
R #1: The trick that I use was a flat head screw driver and tapped the locknut to the left to loosen it up. Then i took a small peace of clear...
http://www.dodgeram.org/tech/dsl/more_power/Power_ve.htm :smile::smile::smile::smile: http://dodgeram.org/tech/dsl/FAQ/diesel_fuel.htm ...
How often should the valves be adjusted on the Gen1 Cummins?
Is the GETRAG transmission in my '93' a Model 360 ?? Thanks in adance............ :thumbsup
well i just got some questions on what did i do wrong? got stuck on a little hill and amost flat soi aready had chains on the back dually they are...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules
