+ Post New Thread
Page 1 of 30 1 2 3 11 ... LastLast
Threads 1 to 20 of 589

Forum: 24 Valve Powertrain Related

Information pretaining to Engine, Transmission and Driveline

  1. Sticky Thread Sticky: VP44 Write Up - Minimum pressure suggested...

    Ok Gang... You all have seen the Dodge FSM book minimum pressure of 10 PSI. Well I started to do some thinging and relized even that is too low. Here...

    Started by Mopar1973Man, 04-14-2010 10:38 AM
    3 Pages
    1 2 3
    • Replies: 43
    • Views: 1,391
    Yesterday 07:27 PM Go to last post
  1. CAD Vacuum

    Anyone know how to test the vaccuum for the CAD 4x4 axle. Specifically - not sure if I have a problem with the CAD itself - or vacuum isn't...

    Started by JOHNFAK, Today 03:01 PM
    • Replies: 0
    • Views: 1
    Today 03:01 PM Go to last post
  2. Where to buy ront Wheel hubs for 2 Wheel drive 01 dually

    ^^^ like the title says I am looking for the best place to buy 2 new front wheel hub/bearing assemblies for my TWO wheel drive 2001 dually. I can...

    Started by smokeythedodge, Today 11:33 AM
    • Replies: 0
    • Views: 9
    Today 11:33 AM Go to last post
  3. Fuel Pressure "Spiking @ Idle and long cruise.

    New fuel pressure problems...I used to have problems with sudden pressure drops, so Installed a Raptor 100 Lift pump. It's worked quite well up...

    Started by Gil2264, Yesterday 10:33 PM
    • Replies: 1
    • Views: 19
    Today 05:45 AM Go to last post
  4. ecm ground

    I have read here about the ground above the atarter for the ecm. will running a new ground from the battery to the ecm serve the same purpose or does...

    Started by dripley, Yesterday 09:06 AM
    • Replies: 7
    • Views: 60
    Yesterday 06:27 PM Go to last post
  5. Ball joint dilemma

    Ok here is my dilemma my truck had just turned 100,000k. I have been having trouble with the ABS when I go to pull in to a parking spot or roll up to...

    Started by little white yj 622, Yesterday 12:17 PM
    • Replies: 4
    • Views: 30
    Yesterday 05:48 PM Go to last post
  6. Possible Problem with 24v Cummins

    Ok. Me and my dad were compairing the 24v to the common rail 24v side my side. I went and pulled the dipstick for the oil and looked at it and my dad...

    Started by Cummins2001, 07-11-2010 07:00 PM
    • Replies: 16
    • Views: 168
    Yesterday 04:15 PM Go to last post
  7. 47re rebuild tips

    here is a great step by step for anyone in the middle of or wanting to do a rebuild on their tranny, the guy has 90% of his posting done and it makes...

    Started by bronzebeard9, Yesterday 03:09 PM
    47re, tranny, transmision
    • Replies: 0
    • Views: 16
    Yesterday 03:09 PM Go to last post
  8. dana 70 rear end question for you guys....

    So i recently changed the fluid in my rear end (85-145 full synthetic) i checked around and was told that 4oz. of friction modifier was the proper...

    Started by bronzebeard9, Yesterday 09:55 AM
    • Replies: 2
    • Views: 27
    Yesterday 01:04 PM Go to last post
  9. Boost PSI

    Any opinions on have much boost i can safely run with a stock fuel system?

    Started by Blueox01, 09-02-2010 08:37 AM
    2 Pages
    1 2
    • Replies: 21
    • Views: 136
    Yesterday 10:28 AM Go to last post
  10. starting hard

    OK I've put a Timbo APPS on and a noise isolator. That took care of the check engine code, however, it is still turning over a while before it wants...

    Started by Lucky2209, 08-12-2010 06:14 PM
    • Replies: 11
    • Views: 119
    Yesterday 06:40 AM Go to last post
  11. 1998.5 24v NO Start

    Hello,My 1998.5 24v would not start after a short trip to UPS. Had the truck towed to my shop. Sat for a few days until I could get a new fuel filter...

    Started by Bremtech, 08-27-2010 05:43 PM
    • Replies: 12
    • Views: 102
    Yesterday 06:38 AM Go to last post
  12. Jhewitt359 having some truck issues.

    He posted his question to the wrong place so I will post what he put so he might have some responses when he gets back. 2002 2500 cummins 4x4...

    Started by ISX, 09-03-2010 06:26 PM
    • Replies: 2
    • Views: 24
    Yesterday 06:32 AM Go to last post
  13. Hot transmission

    Came back from a 1900 mile vacation with the 30ft trailer. Weight w/truck approx 17000lbs to 18000. Part of the trip from Dubious, WY, to about Moran...

    Started by flatbed56, 09-01-2010 04:54 PM
    • Replies: 13
    • Views: 95
    09-03-2010 01:52 PM Go to last post
  14. PAC Brake install

    How hard is it to install a PAC Brake? Think I may be buying one, after I got reading I wonder if I bit off more than I can chew with the install...

    Started by dobienut, 06-24-2010 06:10 PM
    2 Pages
    1 2
    • Replies: 21
    • Views: 255
    09-03-2010 06:56 AM Go to last post
  15. surging

    02 dodge 4x4 - Truck seems to unlock converter from around 50 to 60 mph. RPMs go up and down about 200 rpms. At times the throttle can make no...

    Started by geraldg, 08-22-2010 07:51 PM
    • Replies: 4
    • Views: 70
    09-02-2010 06:03 PM Go to last post
  16. rear output shaft seal (pissing me off)

    Awhile back I noticed some atf on the bottom of my truck just above the front u joint of the rear driveshaft. Anyways last weekend I replaced the...

    Started by IW378, 09-01-2010 06:39 PM
    • Replies: 8
    • Views: 58
    09-02-2010 01:43 PM Go to last post
  17. Manual trans swap.

    Has anyone swaped a auto to a manual? How much did it run you to do it? I want to do this in the future and want to get some ideas on what I am...

    Started by Cummins2001, 05-21-2010 04:43 PM
    2 Pages
    1 2
    • Replies: 27
    • Views: 200
    09-02-2010 12:23 PM Go to last post
  18. ABS sensor

    I have a 2001 3500 w/independent front suspension,is there any way to test the front ABS sensor w/a voltmeter/ohm meter?

    Started by Blueox01, 08-29-2010 09:37 AM
    • Replies: 9
    • Views: 71
    09-02-2010 08:33 AM Go to last post
  19. installing coolent

    I flushed my coolant and let it run till clear, then let it drain. When i add coolant it so far only took 4.5 gal. I drove it around and checked...

    Started by flatbed56, 09-01-2010 04:08 PM
    • Replies: 5
    • Views: 46
    09-01-2010 05:54 PM Go to last post
  20. 2002 24v missing

    hi everybody i have a 2002 cummins and its missing and smoking white at an idle and if you bring the rpms up it starts poping out the exhaust. its...

    Started by kameronk, 08-25-2010 03:57 AM
    • Replies: 12
    • Views: 159
    09-01-2010 04:42 PM Go to last post

+ Post New Thread
Page 1 of 30 1 2 3 11 ... LastLast

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts