+ Post New Thread
Page 1 of 3 1 2 3 LastLast
Threads 1 to 20 of 42

Forum: Powertrain Related

Information pretaining to Engine, Transmission and Driveline

  1. Sticky Thread Sticky: 3rd Gen Error Codes

    P0016 engine speed signal mismatch p0071 inlet air temp sensor rationality p0072 inlet air temp sensor voltage too low p0073 inlet air temp sensor...

    Started by Mopar1973Man, 12-11-2009 03:45 PM
    • Replies: 0
    • Views: 261
    12-11-2009 03:45 PM Go to last post
  1. cummins california spec

    I was wanting to know if there was anyone out there that had any info on an 04 cummins thats a california spec. I would like to know whats done to...

    Started by packinheat2, 08-20-2010 06:18 PM
    • Replies: 8
    • Views: 77
    08-22-2010 07:05 PM Go to last post
  2. turbo help

    ok guys this question was asked of me from a friend he has an 04 commonrail and he asked me if his wastegate could be bypassed to gain a little it...

    Started by Heavyd1980, 08-13-2010 04:28 AM
    • Replies: 6
    • Views: 69
    08-18-2010 01:12 PM Go to last post
  3. Going the VNT route..

    Well I bought a 6.7 Turbo today, it should be here in a week or so. I got the turbo, manifold, and stock coolant lines. Now to save for the...

    Started by AH64ID, 07-27-2010 09:53 AM
    • Replies: 16
    • Views: 116
    08-11-2010 05:22 PM Go to last post
  4. What are the differences between second gen and 3rd gen wit CR

    To increase my thread count and to post over here :) :postwhore: So the 3rd gen come with a common rail rather than vp44 ..... what else ?

    Started by JOHNFAK, 07-30-2010 05:15 AM
    • Replies: 8
    • Views: 88
    07-30-2010 01:00 PM Go to last post
  5. Few questions...

    I got a neighbor up the road from me with a 3rd Gen (03 or 04). He's got a few problems... P0483 - Fan clutch problem? Then high rail...

    Started by Mopar1973Man, 06-19-2010 12:30 PM
    • Replies: 6
    • Views: 92
    07-27-2010 07:30 PM Go to last post
  6. 3rd Gen Cam upgrade

    I broke down and ordered a Cam. Its a Colt Cams Stage 1. Its their mildest grind, but since I dont have big power plans I am not worried about bigger...

    Started by AH64ID, 04-09-2010 11:15 AM
    • Replies: 9
    • Views: 239
    06-30-2010 05:41 PM Go to last post
  7. Coolant Pressure/Flow

    I recently installed a coolant filter, and based on what I thought, and was told, at the time I plumbed it the way I did. I have the "pressure" ...

    Started by AH64ID, 05-25-2010 07:25 AM
    • Replies: 0
    • Views: 65
    05-25-2010 07:25 AM Go to last post
  8. Need some help with codes

    I have a friend with an '06 that has lost power and started running rough. He has a CEL on, and has codes P2149 (bank 2 (cylinders 4-6) shorted high...

    Started by DavidC, 05-19-2010 12:50 PM
    injectors, p0205, p2149
    • Replies: 7
    • Views: 138
    05-21-2010 02:04 AM Go to last post
  9. 03 Loses pressure at temperature

    Just got on this site, was on a different site, called Michael who was very helpful and he assisted me in getting a manual. I am going to post on...

    Started by sdram03, 05-12-2010 12:01 PM
    • Replies: 6
    • Views: 108
    05-18-2010 01:59 PM Go to last post
  10. Wanting to upgrade tranny

    I am wanting to upgrade my stock tranny for towing. My 10k lb rv really puts a load on my tranny especially climbing hills. I know there are allot of...

    Started by turbopilot51, 04-24-2010 07:37 AM
    • Replies: 3
    • Views: 115
    04-30-2010 07:45 PM Go to last post
  11. Finally Got My Truck Fixed

    It took a while, but it's done. I initially took it in to have the front seal replaced, find the "thumping" in the front end and to "time the CP3". ...

    Started by dorkweed, 04-16-2010 04:24 PM
    cp3 phase, cp3 timing, oil leak
    • Replies: 8
    • Views: 193
    04-22-2010 02:59 PM Go to last post
  12. Issues with an '06

    I posted the below info in the 2-stroke thread, but this is really the place it should be kicked around. Any opinions are appreciated. "I have run...

    Started by NBWW, 02-20-2010 04:55 AM
    • Replies: 16
    • Views: 417
    04-16-2010 07:01 PM Go to last post
  13. Amsoil bypass kit

    Hey everyone its been awhile since ive been on here. I was just thinking about putting an amsoil oil filter kit on my 04 2500 and was wondering if...

    Started by packinheat2, 04-07-2010 02:27 PM
    • Replies: 3
    • Views: 150
    04-09-2010 09:33 AM Go to last post
  14. Smoke Switch Install

    Hello everyone. I'm new here, I have been on cumminsforums for a while though. Thank you moparman for all of your time and dedication to putting...

    Started by BrendonTW, 02-26-2010 09:37 PM
    • Replies: 6
    • Views: 754
    03-07-2010 09:50 AM Go to last post
  15. Common Rail Fuel system explained in Video

    Check this out gang... This is a excellent YouTube Video that explains the basics of the CR injector and operation of the fuel system...

    Started by Mopar1973Man, 03-03-2010 06:59 AM
    • Replies: 0
    • Views: 143
    03-03-2010 06:59 AM Go to last post
  16. How to clean a turbo

    I've gone back to my stock air box after finding some grim and dirt on my turbo fins. My question is there a quick and easy way to clean the inside...

    Started by AlCorr, 02-22-2010 03:46 AM
    • Replies: 4
    • Views: 465
    02-22-2010 08:14 AM Go to last post
  17. 2003 HO Cummins wont start

    This truck ran perfect yesterday and will not start at all. It cranks fine and I replaced the lift pump and fuel filter. There is no smoke at all and...

    Started by felix2464, 01-25-2010 08:54 PM
    • Replies: 8
    • Views: 356
    01-28-2010 07:10 AM Go to last post
  18. Done Experimenting

    Just over a month ago........when the really cold weather got here..........I decided to experiment with the Smarty setiings on my truck. Well, for...

    Started by dorkweed, 01-22-2010 02:55 PM
    • Replies: 9
    • Views: 342
    01-23-2010 04:23 PM Go to last post
  19. injection lines

    what are the benifits or disadvantage of ss lines? I have metal shaving in the stock ones and have to replace them was thinking of going with .093 ss

    Started by 04dodge, 12-29-2009 04:28 PM
    • Replies: 12
    • Views: 508
    01-10-2010 02:24 PM Go to last post
  20. CP3 Failure

    Just completed diag on 03 DR 3500 nostart, using TSB 14-003-06 RevA, as directed by Chrysler. Truck has 144K, no mods at all. In tank lift pump...

    Started by Ed'sTransmissionService, 12-24-2009 04:12 PM
    • Replies: 9
    • Views: 501
    01-08-2010 06:55 AM Go to last post

+ Post New Thread
Page 1 of 3 1 2 3 LastLast

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts